|
Tip
#50
Using
a Jointer (continued)
Click
here for a printer friendly version of Tip -
Pg 1-3, Pg 4-6,
Pg 7-9,
Pg
10-11, Pg 12-13
Help with Downloading
PDF Files
Jointing
End Grain
|
|
|
Figure
6-10.To
reduce splintering, (A) make one pass to about this
point; then (B) turn the stock end-for-edn and make
a second pass until it meets the first one which, here,
is indicated by the arrow. Note: The guard is removed
and the depth of cut is exaggerated for clarity.
|
End grain
jointing is always difficult because you're jointing at the
worst possible angle to the grain. For most projects, end
jointing is not even necessary. But when you need to do it,
follow these steps:
Take very
light cuts (1/32" or less) and feed the work as slowly as
is practical. Check to be sure the jointer knives are sharp
or they may burn the end grain during the cut. Joint the ends
before jointing the edges so that any minor splintering will
be removed. Splintering can also be reduced by jointing about
2" in from one side, then reversing the piece to complete
the cut (Figure 6-10). You may also want to score the wood
fibers at the very end of the cut with a chisel or utility
knife before jointing.
Continue
to Jointing Four Edges
Back to Edge Jointing Problem Stock
|
