|
Tip
#52
Shopsmith Jig Saw
(continued)
Click
here for a printer friendly version of Tip-
Pg. 1-4, Pg
5-8, Pg 9-12, Pg
13-16
Help
with Downloading PDF Files
Jigsaw
Safety
Warning:
Before using the jigsaw read and understand these important
safety instructions:
Danger
Zone-The jigsaw danger zone is 3" out from the blade in
all directions. When you're using the jigsaw as a sabre saw,
the zone extends to 12" above the blade.
- Wear
proper eye protection.
- Remember
that part of the blade extends beneath the table. Never
reach beneath the table to adjust the table tilt, to tighten
the Mark V accessory mount lock, or for any other reason
while the machine is running. Turn off the jigsaw first
and let the blade come to a complete stop.
- When
removing jigsaw blades, remember that these blades are tensioned
by a strong spring. If you loosen the locking screws in
either chuck without first releasing the tension, the upper
blade chuck will snap back in the tension tube, possibly
damaging the jigsaw or injuring you.
- Always
turn the jigsaw on first, then feed the workpiece into the
blade. Never turn on the machine with stock pressed up against
the blade.
- Don't
use worn, dull or damaged blades. They have a tendency to
heat up and snap while you're working.
- Recondition
or replace worn blade guides immediately.
- If
you're using a Shopsmith Power Stand, be sure you're using
the proper pulley and belt combination and that the pulley
and belt are properly guarded.
Continue
to Jigsaw Speeds
Back to Patterns and Layout
|
