Tip #17
Disc Sanding (continued)
Click here for a printer friendly version of Tip-
Pg. 1-4, Pg 5-8, Pg 9-11, Pg 12-14

Sanding Miters & Bevels

Figure 17-11. When sanding angles on the Model 500 use the quill to move the disc toward the stock.

You can sand bevels and miters by tilting the table or adjusting the angle of the miter gauge, just as you do when sawing bevels and miters. Use the quill feed to move the disc toward the stock on the Model 500 (Figure 17-11). When sanding angles on the Model 510, position the disc through the table saw insert (Figure 17-12).

Figure 17-12. When sanding angles on the Model 510, position the sanding disc through the table saw insert.

Continue to Truing Miters & Bevels
Back to Edge Sanding