|
Tip
#29
Doing
Jointery on Your Table Saw
Click
here for a printer friendly version of Tip-
Pg. 1-3, Pg
4-6, Pg 7-9, Pg
10-12, Pg 13-15,
Pg 16-18, Pg 19-21, Pg
22-24, Pg 25-27, Pg
28, Table
3-1
Lock
Corner Joints
 |
|
Figure
3-77. Procedure for making a lock corner joint on
3/4" stock. Accuracy is critical. (A) Cut a 1/8"
x 1/8" dado, 5/8" from the edge. (B) Cut a
1/8" x 1/8" rabbet. (C) Cut a 1/8" x
1/2" rabbet to form the 1/8" x 1/8" tongue.
(D) Form a slot 3/8" x 3/4". (E) Cut off one
side of the slot and cut a 1/8" x 1/8" dado.
|
Joints
of this type are a challenge to do, but they hold together
beau-tifully. Figure
3-77 shows the typical procedure on 3/4" stock. Accuracy
is critical.
Continue
to Joint Applications
Back to Finger Joints
|
